The F4V2/F4V3 differential expansion board connects directly to F4V2 or F4V3 without the need for a 40-pin ribbon cable.

The board has two RJ-45 connectors. Each connector can drive a.

The F8-Distro Board is an eight port power distribution board. The board has one 30amp power input connector and eight 5A connectors. The connectors are pluggable connectors for easy.

Works with F16V4 only. 

The F16V4 Expansion Board connects the F16V4.

Completely Assembled. This board expands a F16V4 pixel controller to give controller another 16 ports. Two.

50The new expansion boards has two 40-pin connectors.

The Differential Expansion Board connects the the F16V2 or F16V3 via 40-pin ribbon cable. Allows up to four receivers to be connected.

The new expansion boards will have two connectors. (Not shown in image)

F16v2/F16V3 Expansion Board with ribbon cable

Completely Assembled. This board expands a F16v2/F16V3.

Falcon F-Amp with xConnect Pigtails

The F-Amp with xConnect Pigtails include a male and female connector. Sealed epoxy for complete waterproof solution.

Falcon F-Amp with Ray Wu 13.5mm Pigtails

The F-Amp with Ray Wu 13.5mm Pigtails include a male and female connector. Sealed epoxy for complete waterproof solution.

Falcon F-Amp

The Falcon F-Amp is a line buffer designed to boost the data signal that controls 3-wire pixels. The F-Amp can be attached directly to the pixel controller or can be placed.

Eight pack of 3.5mm connectors. Fits F16V3, F4V3, F16V2R, F16V2 expansion boards and receivers.

Eight pack of 3.5mm connectors 3-pin. Fits SmartReceiver v2.0 as well as F48V4.

40-Pin Ribbon Cable. Works with F16V2/F16V3 Expansion Boards.

Two 3-pin pixel connectors and one 2-pin power connector for Picap. The Picap comes with these connectors. These are for replacement of connectors that will ship with Picaps.